This Model is now replaced by FSP300-60GHC. Please go to this part on our eshop and order it there. Thank you.
FSP300-60GLC power supply is High efficiency with Low ripple & noise. Output over voltage protection. Short circuit protection on all outputs.
Dimension : 140 x 150 x 86 mm.
Application : For PC
Watt : 300
PFC : Active.
Connectors 1 x 20+4 way, 1 x 12vP4, 2 x SATA, 6 x 4 way Molex, 1 x Floppy Drive, 1 x PCI Express. • Resettable power shut down • Approved by UL, CSA, TUV, NEMKO, CB & CE • Internal 8 cm fan • Under 40dBA noise design at full load • 100% burn-in under high ambient temperature (50°C) • Vacuum-impregnated transformer • MTBF: 100K hours at 25°C • 100% Hi-pot tested • Line input fuse protection • Active PFC (Power Factor Correction) circuit • Complies with EN61000-3-2 • AC input full range
| Input Specifications |
• Voltage:
|
100-240 VAC full range |
| • Frequency: |
47 Hz to 63 Hz |
| • Inrush current: |
60A cold 90A warm at 132 VAC |
| • Input current: |
5 amps maximum / 115 Vrms, 60 Hz.
2 amps maximum / 230 Vrms, 50Hz. |
| |
| Output Specifications |
| • Over-voltage protection: |
+5V, +3.3V, +12V1, +12V2 |
| • Over-current protection: |
+5V, +3.3V, +12V1, +12V2 |
| • Overload protection: |
150% max. |
| • Remote ON/OFF control: |
The power supply shall accept a logic collector level which
will disable / enable all output voltage (excluding +5V standby). |
| • Power good signal: |
turn-on delay 100 ms to 500 ms |
| |
| General Specifications |
| • Efficiency: |
75% min., at full load |
| • Hold-up time: |
17ms minimum at full load & nominal input voltage |
| |
| Environmental Specifications |
• Temperature range:
|
operating 0°C~50°C, storage -20°C~+80°C |
| • Humidity: |
5~95% RH |
| • Dielectric withstand: |
input / output 1800 VAC for 1 second,
input to frame ground 1800VAC for 1 second |
| Output |
| Output Voltage |
Min. load |
Max. load |
Load Reg. |
Ripple & Noise |
| +3.3V |
0.5A |
20.0A |
±5% |
50 mV P-P |
| +5V |
0.3A |
20.0A |
±5% |
50 mV P-P |
| +12V1 |
1.0A |
8.0A |
±5% |
120 mV P-P |
| +12V2 |
1.0A |
14.0A |
±5% |
120 mV P-P |
| -12V |
0.0A |
0.8A |
±10% |
120 mV P-P |
| +5Vsb |
0.0A |
2.0A |
±5% |
50 mV P-P | | |
