THIS PART IS NO LONGER AVAILABLE.

2U Power Supply 300W Zippy Emacs P2U-6300P. Maybe replaced with 350 watt Seventeam ST-P0350WAB.

Input:

VOLTAGE: 103 ~ 264 VAC
FREQUENCY: 47~63HZ
INPUT CURRENT: 6A/3A AT 110/220VAC
INRUSH CURRENT: 40/80A AT 110/220VAC

Features:

l            TEMPERATURE RANGE: OPERATING:0℃ --- 40℃

l            HOLD UP TIME: 16 ms MINIMUM AT FULL LOAD & NORMAL INPUT VOLTAGE

l            DIELECTRIC WITHSTAND: INPUT / OUTPUT 1500 VAC FOR 1 SECOND

INPUT TO FRAME GROUND 1500 VAC FOR 1 SECOND

l            EFFICIENCY: 60% TYPICAL

l            POWER GOOD SIGNAL: ON DELAY 100 ms TO 500 ms, OFF DELAY 1 ms

l            OVER LOAD PROTECTION: 130 +/- 20%

OVER VOLTAGE PROTECTION: +5V à 5.5V ~ 7V, 3.3V à 4.0 ~ 4.5V

l            SHORT CIRCUIT PROTECTION: +5V, -5V, +12V, -12V, +3.3V

l            EMI NOISE FILTER: FCC CLASS A, CISPR22 CLASS A

l            SAFETY: UL 1950, CSA 22.2 NO/ 950, TÜV IEC 950

l            REMOTE ON / OFF CONTROL

THE UNIT SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE / ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STANDBY),

AS LOGIC LEVEL IS LOW, OUTPUTS VOLTAGE WERE ENABLE,

AS LOGIC LEVEL IS HIGH, OUTPUTS VOLTAGE WERE DISABLE.

l            3.3V / 5V REMOTE SENSING

l            COOLING: TWO 60mm DC FANS

l            DIMENSION: 200 (D) x 100 (W) x 70 (H) mm

l            MEET IEC-1000-3-2 CLASS D

l            OVERHEAT PROTECTION : SHUT OFF

Dimensions:

200x100x70(mm)

Connectors:

1 x 20 pin, 1 x 12vP4, 6 x Molex HD, 2 x Floppy Drive

Cable Length : ATX 430mm / Peripherals 600mm

Inc 2 x Mounting brackets

REMARKS: (1) TOTAL CURRENT OF 5V & 3.3V NOT EXCEED 35A (2) TOTAL POWER OUTPUT NOT EXCEED 300W